6.4. Pick

6.4. Pick
	6. Noise Filters

6.4.1. Overview

Figure 17.130. Example of applying the “Pick” filter

Original image

Filter “Pick” applied

The Pick filter replaces each affected pixel by a pixel value randomly chosen from its eight neighbours and itself (from a 3×3 square the pixel is center of). All or only some pixels in an active layer or selection are affected, the percentage of affected pixels is determined by the Randomization (%) option.

6.4.2. Activate the filter

You can find this filter through Filters → Noise → Pick….

6.4.3. Options

Figure 17.131. “Pick” filter options

Random seed

Controls randomness of picking. If the same random seed in the same situation is used, the filter produces exactly the same results. A different random seed produces different results. Random seed can be entered manually or generated randomly by pressing New Seed button.

When the Randomize option is checked, random seed cannot be entered manually, but is randomly generated each time the filter is run. If it is not checked, the filter remembers the last random seed used.

Randomization (%)

This slider represents the percentage of pixels of the active layer or selection which will be picked. The higher value, the more pixels are picked.

Repeat

This slider represents the number of times the filter will be applied. Higher values result in more picking, pixel values being transferred farther away.